Uncontrolled starting of amusement devices
Last Updated: 23/03/2018
The purpose of this safety alert is to provide information on an incident with a Wave swinger amusement ride with a design feature common to many older amusement devices.
A Wave swinger amusement ride unexpectedly started to rotate at high speed while patrons were getting off the ride. Fortunately, the operator activated the emergency stop and managed to stop the ride with the help of the foot brake. Although patrons received only minor injuries, potentially the incident could have been far worse. Figure 1 is a photo of a typical Wave swinger ride.
Figure 1 – Photo of a Wave swinger amusement ride
The Wave swinger ride involved in the incident was manufactured in 1977. During our investigation, the ride’s electric over hydraulic control system was tested but the fault could not be identified. However, it has been confirmed that the ride did not have safeguards in the control system (which are normally installed in modern machinery) to prevent uncontrolled re-starts.
To prevent similar incidents on amusement devices manufactured before 2008, a risk assessment should be conducted to determine operation areas which, if not protected by safety features, can result in serious injuries. These include unexpected starting of the amusement device, the emergency stop, locking of entries to hazard zones of the device while it is in operation and rider restraint interlocks. Areas with high risks should be upgraded to the level of machinery safe-guarding required by technical standards such as Australian Standard AS 4024 Safety of machinery and International Standards Organisation ISO 13849 Safety of machinery – Safety related parts of control systems (or equivalent).
Owners of amusement devices must have an engineering assessment conducted on the control system of their amusement devices to determine whether an upgrade is required. This assessment should be conducted within 12 months of this safety alert being issued, either separately or as part of the annual inspection. The engineer should recommend the timeframe for any required upgrade to be implemented.
Further information can be obtained from the following:
- Australian standard AS 3533 on amusement devices
- Australian standard AS 4024 on safe guarding of machinery
- Technical standard EN ISO 13849-1/-2: Safety of machinery – Safety-related parts of control systems
- Managing risks of plant in the workplace Code of Practice 2013 (PDF, 1477.22 KB)
- Last updated
- 23 March 2018
Are your contact details up to date?
Make sure you are receiving information related to your WorkCover policy. Review your contact details online by logging into WorkCover Connect. Once logged in, select 'Contact > Change premium contact details' from the menu, and update if required.